This is how I replaced my VW Beetle Tail light. Things you will need: *Flathead Screwdriver *New tail light bulb (7528 Sylvania) *Gloves-Use gloves, so you do not touch the tail light bulb. Plus its easier to grip the tail light bulb. The grease/oil from your hands, even if you just washed, it will make the bulb burn out faster. Step 1- Remove the cover (it's round) from the inside of your trunk. Use a flathead screwdriver to leverage it out. There is a notch on one side so you can slip the flathead screwdriver in to pop it out. When you take that part off, there will be a black knob that needs to be unscrewed totally to release the back light casing. Step 2- Along the rear fenders where the lights are, there are two gaps. The inside gap (nearest hatch back door), is a release tab/clip on the light inside between the gaps. Insert a butter knife or something slim and pull out the casing (it takes a little force to pull it out). Step 3- After you pull out the casing, you'll find two light switches (one is for the turn signal, and the other is for your brake light). Turn the light switch counter clockwise (assuming it's hanging upside down) and remove. Step 4- Switch the tail light bulb with new one (Advance Auto Parts: $4.17) There are little dots on the bottom of the bulb that need to be in the right place. You will notice that one is higher than the other. They need to be in the right slot otherwise it will not work. Step 5- Replace everything back as you uninstalled it. I also recommend to replace all the bulbs, that way you don't have to do it again later when they go out. It'll save you lots of time... Hope this helped! :)
you don't replace the tail light you just replace the bulb in it
This is because the tail light bulb has a different element in the bulb. Just replace the bulb and that will fix the problem.
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
Remove two screws holding tail light assembly. Pull or Pry out tail light assembly. Locate center wire plug harness, turn to remove, pull out bulb, push new bulb in.
You will need to open the liftgate and remove the screws that hold in the tail light housing. Once removed, you can twist the bulb socket slightly to remove it from the housing and replace the bulb.
Question isn't clear. Are you asking how do you replace the bulb -OR- how to remove the entire lens assembly?
sedan model: from the trunk pull out the carpet retaining screws/plugs to access the tail light assembly mounting screws. pull them out, pull the tail light assembly out. from here you can replace any needed bulb.
Replace the light bulb. Tail lights are usually dual filament, 2 filaments in one bulb.
take it to chevy
Turn you high beams on and check your tail light. If its brighter, you have a head light bulb as a tail light bulb. 97-02 are the only ones that should do this. Find a tail light bulb and replace.(I couldn't believe it either).
Remove carpet inside trunk that covers tail ligh assembly, then unbolt tail light assembly, remove the assembly and bulb fixture of the bulb you want to replace, replace bulb and re-install in reverse order.
remove tail light, remove burnt bulb, replace burnt bulb, test if it works, then put tail light back on....