I have an 02, but it should work the same way. Unscrew the tail light cover from the outside, then pull it off.
you have to remove the cover of the dashboard to replace the light bulbs
advtrac light will not go off
If you need to replace the bulbs take out the two bottom screws under the front of the car in front of the tire. And then take out the three plastic retainers they go accross you can't miss them, and this will give you plenty of room to replace the bulbs.
lift open rear door, unscrew two screws, pull out light assembly straight back, but not to far because wires for light bulbs does not extend long. take your time ,simple job.
There are two screws on the inside of the tail gate that have to come out and then you just work the covere off to get to the bulbs
To change headlight bulbs in a 2005 Ford Escape, first make sure the light switch is in off position and replace the passenger light bulb. Next, get to the driver's side bulb, remove the battery by holding it down, to be able to change the headlight bulb.
open rear door, remove Phillip screws, the in tire assembly comes out, now you have access's to bulbs.
No,a transmission on a 2005 mercury mountaineer will not fit on a 2000 mercury mountaineer unless you change the oil message on the mountaineer.
there is 3 bulbs
The cover comes off with easy prying on the side of the plastic case over the assembly. Then, the bulbs holder comes out with a slight twist. The bulbs can then be pulled from the bulb holder.
Top Light is H7 Bottom light is HB3
H1 size Bulbs