To get to the rear taillights you just need a 10mm socket or wrench. there are two bolts at an angle in the bed of the truck just inches in from the tailgate one over the other. if you have a bed liner youll need to remove or at least pull the farther back section out a bit to see the bolts. then just remove the two bolts and pull the tailight assembly straight out. and put back together in reverse order hope this answers your question.
Added: If you have a tailgate extender, these two bolts double as the bolts for the extender bracket. There are also two plastic "pop out" fasteners along the outer side of the lens assembly (re-emphasize "pull straight out"). I also had to remove the whole bed liner. To do this, remove the 4 plastic retaining fasteners then pull the liner forward, tilt up and out. Easier with two people. Thanks to the original poster!
A 2002 Nissan Frontier bed will not fit a 2000 Nissan frontier.
Replace the hub bearings.
The turning circle for that 2000 Nissan Frontier SE is 33.4 ft.
15.9 Source: http://www.vehix.com/car-reviews/2000/nissan/frontier/vehicle-specifications
The vehicle with the same distributor as a 2000 nissan frontier XE V6 3.3 liter engine is the 2001 Nissan Frontier, 3.3L V6.
The manufacturer recommends that you change your 2000 Nissan Frontier four-cylinder engine timing belt every 60,000 miles. The 2000 Nissan Frontier does not have a timing chain, it has a timing belt.
What kind of transmission fluid do you use for Nissan Frontier 2000?Read more:What_kind_of_transmission_fluid_do_you_use_for_Nissan_Frontier_2000
The 2000 Nissan Frontier radio has two fuses. There is an in-line fuse behind the radio. There is a fuse in the fuse box.
The PCV valve on a 2000 Nissan Frontier 2.4 is on the top back part of the engine. It is attached to the intake manifold via a hose.
It is in the gas tank.
easiest safest and fastest way is to simply unbolt bed disconnect taillights set bed back and its right behind drivers side . i did mine in less than an hour and ahalf it took four of us to set bed back and reinstall clean job...
2000 Nissan/Datsun Truck Frontier Pickup 2WD 2.4L SFI 4cylThe Spark Plug Gap.044 (In thousandths of an inch)
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
3.3liter or 3.48 qt engine oil
How do you replace dashboard light on 2000 Nissan almera
If the 2000 Nissan Frontier has fewer miles on it, it is recommended that the oil weight should be 5w30. If the car is more miles on it, the recommended oil weight should be 10w30.
2000 Nissan xterra cabin air filter
what are the ignition timing of the Nissan frontier 2010 3.3 liter
theres no adjustment. need to replace the clutch.or if clutch is new you need to bleed the slave cilinder by the transmission
try autozone for a haynes repair manual
AnswerMy 1999 Frontier actually has two oxygen sensors. One in front of the catalytic converter "upstream" and one after "downstream" which constitutes double the cost.The best thing to do is find out which one is bad before you replace them.P.S. the catalitic converter is inline with the exhaust system.Additionally, You can get the Entire "2000 Nissan Frontier" Official Service / Repair Manual for less than 10 bucks.
2000,nissan frontier speakers size-------6 1/2 Try to use the Nissan speaker adapters plugs so you don't need to cut wires and mess up the electric system, you can get those from eBay or amazon.