Thermostats
Geo Prizm

How do you replace the thermostat located on a 1994 Geo Prism?

313233

Top Answer
User Avatar
Wiki User
Answered
2006-06-29 00:27:27
2006-06-29 00:27:27

Drain some anti-freeze from the radiator, remove the top hose from the housing, take the 2 nuts off that attach the housing to the head and pull it off. Pull the old thermostat out and install a new one. Make sure you get a new gasket for the new t-stat. Don't re use the old one.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions



where do i find the thermostat for 99 cavalier


The thermostat is located in the thermostat housing at the engine end of the top radiator hose.



The 1994 Chevrolet Beretta thermostat is located on the front of the engine. You can follow the top radiator hose directly to the thermostat housing. The thermostat will be in the thermostat housing.


how do you replace thermostat on 1994 Honda civic dx


Follow the top radiator hose back to the engine. This is where the thermostat is. Remove the 2 bolts and there it is.


It is in the housing at the engine end of the upper rad hose. When replacing it make sure the spring on the thermostat is toward the engine.


The thermostat housing is located on the driver side between the distributor and the transmission. There are two 12mm bolts holding the the thermostat housing. You may want to disconnect the white colored sensor before removing the housing. The thermostat is located underneath the housing.


Follow the upper radiator hose to its end. The thermostat is located right about there.


Thermostat is located at front of motor between ac compressor and alternator.


This question has already been answered. Just check a few questions before yours.


How to install thermostat in a 1994 volkswagen golf?


There is 2 of them and they are located on either side of the thermostat housing.


in the thermostat housing engine end of the top hose


THE thermostat IS IN THE HOUSING ON THE ENGINE SIDE OF THE LOWER RAD HOSE.


Follow the lower radiator hose into the housing, that where the thermostat is.


Most thermostats are located in the thermostat housing which is at the lower end of the large top radiator hose.


It is located at the engine end of the upper rad hose. When replacing it make sure the spring goes toward the enigne.


Thermostat locationI own a '91 Probe GL, which is 4 cylinders, and the thermostat is located in the housing which is at the engine end of the radiator hose coming from the top side of the radiator. Just look for that main hose, and follow it to the cylinder head. The thermostat should be in that housing. -ShaunThe thermostat is located on the right side of the engine looking in, in between the intake manifold and the air filter box, underneath the wiring. This is in a 1994 Ford Probe GT 6 cylinder.To replace the thermostat, you really need to remove the intake manifold and this can be up to two or three hours work alone, even for a qualified mechanic.


FOLLOW THE UPPER RADIATOR HOSE , TO THE TOP OF THE ENGINE .WHERE THE HOSE CONNECTS , THE THERMOSTAT LAYS INTO THE INTAKE MANIFOLD , BE SURE TO GET A GASKET WHEN YOU PURCHASE THE THERMOSTAT !!I DONT USE ANYTHINNG BUT FEL-PRO GASKETS AS THEY ARE BY FAR THE BEST !!!SPITNHARD79


On the 1994 Lexus 300es, the thermostat is located in the front of the engine. Look for a radiator hose just below the location of the water pump. The thermostat is inside the end of that hose.


The thermostat is located on the front of the engine. It is behind the timing belt on the right side.


The thermostat is located under the housing where the upper radiator hose hooks to the engine.


Located at the rear of the waterpump, under the inlet manifold



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.