The thermostat is located in the cooling neck located at the end of the cylinder head next to the distributor. Instructions: Drain coolant, remove both bolts to thermostat housing (one bolt may not come completely out because of a sensor and expect much coolant to pour out), unstick the thermostat housing from the engine, remove thermostat from engine, clean all gasket surfaces, install thermostat in engine with the spring towards the inside of the engine, install gasket with thermostat housing, tighten bolts, fill coolant, start and check for leaks.
how to replace the thermostat on a 2003 Mazda protege es 2.0
where is the thermostat on a 1999 mazda protege?
Where is the thermostat location on mazda protege 2003?
how do replace the thermostat on a 1999 mazda b2500 truck?
follow the bottom radiator hose up to the engine and remove the two bolts an you should see it
thermostat is located where the lower hose conects to the engine
Could you tell me how would you replace the oil pump on a Mazda Protege?
Follow the upper rad hose from the radiator to the engine and you will find a housing thas has the thermostat. Take the housing off and when you reinstall the thermsotat, make sure the spring is toward the engine.
How do you replace power steering belt on 2003 Mazda protege ?1.6
where is the transmission shift solenoid located on a 2001 Mazda protege
Where is the EGR Valve on a 1996 Mazda Protege located at?
How you replace the cabin filter mazda protege 5 2003
Where is the flasher relay on the 1999 mazda protege
it is the same for all Mazda with a v6
Where is the thermostat located on a 1999 Mazda 626?
Where is the thermostat located in a 2001 Mazda mpv
If your heater does not work on your 94 Mazda Protege, check the thermostat. You can also check the heater fuse to ensure it has not blown.
that is the cooling fan relay.
no sensor only a thermostat
how do u replace alternator belt on 2002 mazda protege 5 stationwagon
I have a 2000 Mazda protege. My fuel filter is in the gas tank and is not something you can replace. John B.
my 1998 4 cylinder protege is under left of air filter right of engine I think.
you can't fix a sensor, you can replace one by removing it and installing the new one...:)
it is located on the motor in the front
I just replaced my fan belts on a 2002 Mazda Protege. It came out to a little over $200. I took my car to a Mazda dealership.