Thermostats
Mazda 626
Mazda Protege

Where is the thermostat location on Mazda protege 2003?

567

Top Answer
User Avatar
Wiki User
Answered
2009-09-17 03:40:44
2009-09-17 03:40:44

Where is the thermostat location on mazda protege 2003?

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how to replace the thermostat on a 2003 Mazda protege es 2.0

location cylinder 2 mazda protege

How you replace the cabin filter mazda protege 5 2003

Bottom of the engine on the oil pan.

How to know if air sensor not working on protege 2003

How do you replace power steering belt on 2003 Mazda protege ?1.6

no it will not fit.it is not the same lenght and the same height

1964-2003 and after that evolved into the mazda3

The 2003 Mazda Protege holds 3.7 quarts of oil approximately. Add a little less, then check with the dipstick to avoid over filling.

Directly in front of the driving seat.

No, they are different cars. Even though the Mazda3 replaced the protege they do not have many if any parts in common.

thermostat location on 2003 Nissan altima

Yes, you can use 10 W 30 motor oil in a 2003 Mazda Protege. If you live in areas where the temps are very cold, 5 W 30 is recommended.

A spark plug for a 2003 Mazda Protege has a 14 mm thread size, and a 19 mm reach. The gap is 1.1 mm.

The kind of antifreeze that is recommended for the 2004 Mazda Protege is the Genuine Mazda Long-life Coolant. You can also purchase Peak or Zerex coolants which are also considered compatible.

You need OBD2 reader or scanner to get the codes

open your glove box..at the back of it you see the ECM.

The firing order on a 2003 Mazda Protege DX 2.0 is 1, 4, 2, 5, 3, 6. The number 1 cylinder is on the back right as you face the engine.

6x9 in the front doors 6.5 in the back doors

On a 2003 Mazda Protege it must be changed at 105,000 miles. This is an interference engine and as such if the belt breaks serious engine damage will occur.

i like interstate batterys have them in both my cars

It should be underneath the throttle body on the back of the intake manifold

No, you need a press to remove and install the bearing.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.