To remove the throttle position sensor:
1. Unplug the electrical harness.
2. Remove the bolt that holds the tps in place.
3. Remove the tps.
To install a new tps reverse the removal procedure. There is no adjustment given.
NO ajust on tps sensor,. Replace
It is attached to the throttle body exactly opposite the cam/lever with the cable(s) on it.
tps will be located other side ofthrotle to accel cable check for clean connection at tps plug replace tps unless you can test unit dave.cop
TPS is located on the TBI unit (front right)and cannot be replaced. you have to replace the entire TBI
Same procedure. http://www.fullsizebronco.com/forum/showthread.php?t=53840&highlight=ultimate+tps Good Luck!
Code p0507 2001 chevy s10 replace upper intake, iac, tps still have problem
There is a test procedure for that using an ohm meter. Consult a Chilton's or similar repair manual.
how to replace tps on 95 chevy 6.5 turbo diesel 1500
If spark plugs didn't help also check or replace the TPS. "Throttle position sensor"
I had the same problem with my 02. had to replace the EGR Valve.
The throttle position switch (tps) is located on the throttle body.
According to my factory service manual the voltage at the throttle position sensor should vary from about 0.5 volts in the idle position to 5.0 volts in the wide open throttle position.