Turn ignition switch on, press accelerator pedal to floor rapidly 3 times, start engine and light should go out. Do not press more then 3 times as then it will not reset.
1995 ford 7.3 won't accelerate when i press the accelerator
Probably because the light is burned out. It is pretty easy to change.
You accelerate if you press it.
to shift from lo to hi range; press in on accelerator, pull control switch up, release accelerator and pause to allow axle to upshift. to shift from hi to lo range; press in on accelerator, push control switch down, release and press down on accelerator quickly. declutching is not necessary.
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
key on engine off press accelerator pedal to the floor five times very rapidly should reset
Why does the engine slow down when you press the accelerator on a 90 Plymouth grand voyager LE 3.3L?
With the car on, press the accelerator pedal.
just hit it harder
When you press the accelerator and brake together in a motor car, the engine will rev, but the brake will stop it from moving. Doing this repeatedly can cause the vehicle damage.
Just press the accelerator.
Air trapped in the heater system. Be sure the coolant reservoir is full and the radiator cap is good.
replace the fuel filter and the accelerator cable to the throtle body
If its a front wheel drive car , you automatically push the accelerator but not to hard and turn into it not with it. A 4 wheel drive car you turn into it and press the accelerator and finally rear wheel drive you let go of the accelerator and turn into it
No. The cruise control will maintain the vehicle speed you have selected.
I have a 2000 Mercedes S430 I recently replace the left rear shocks and the accelerator won't work when you press it down. the engine starts but with the accelerator pressed down the car will not move. the engine sound will not change. Please I need help to have an idea what I'm dealing with thanks.
it helps you press the brakes and accelerator.
No, you just hit the brakes HARD.
It should start right up. If not, press the accelerator slightly
There shouldn't be. You should see a mechanic.
Incorrect fuel pressure. Plugged fuel filter.
sorry for my English y am from holland turn ignition on press 3 themes on the accelerator turn ignition of wait 15 sec if necessary repeat this a few thems good luck That would be for the change oil light i believe.
In my case(chevy venture van2000)the diagnostics showed the torque converter clutch is sticking. That means about 6-700.00 to repair.This is a touchy one because it means that your transmission is troubled.Better get it fixed asap!