0
how to replace tps on 95 chevy 6.5 turbo diesel 1500
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Throttle position out of range?
ANSWER: Need make, model and year to be able to tell you how to reset the throtle position.
How do you reset the throttle position sensor?
how do you reset the throttle position sensor on a Ford Taurus 3.8 1992
How do you reset sensor on infinity M45 2004 after a tire rotation?
The sensors are wheel position specific. They should reset themselves. If they are not in correct position they will not reset.
Where is the cam sensor reset button located at on 1999 ford diesel super duty 7.3?
there is no reset button for the cps
How do you reset the tps ona 1992 Mazda protege throttle position sensor?
check the manual
Hi there you have a 1999 dodge ram diesel with bad tps throttle position sensor code p0123 I've replaced it but still when you push the throttle?
the code P0123 means, Throttle Position Sensor/Switch A Circuit High Input. sounds like a wiring problem to me. I had the same problem with a 99 Toyota tocoma when i replaced it i had to reset the CPU. On a dodge you should be able to disconnect both batteries for 15 mins to 1 hour and it mite reset.
How to reset fuel filter maintenance light on dash for 200 series diesel landcruiser?
remove the black plug from sensor on top of the filter with ignition in the off position,start the engine,replace the plug and the light will be off. I tried this but the light is still on!
How do you reset o2 sensor to pass smog 2004 dodge ram 2500 diesel?
It has to be repaired. A recent reset is an auto fail. You can't have any resets in last 100 miles, but it is easy and cheap to replace
How do you reset the oxygen sensor?
An Oxygen sensor does not reset. You have to replace them and yes they are expensive.
How do you reset check engine light on Jeep Liberty diesel?
How do you reset engine light on jeep liberty diesel
How do you reset change oil command on a 2010 Dodge ram 2500 diesel?
If I remember it correctly. YOU TURN THE KEY TO ''"ON"" POSITION. THEN DEPRESS THE DIESEL PEDAL 3 TIMES. (aka=the gas pedal) AND THAT SHOULD DO IT.
When Ireplaced cam shaft position sensor the light stayed on and the computer says that it is still that sensor?
you need to do a system reset. push the setup button on your dash a couple times until it gives the option to reset. then hold the reset button for 3 sec. hope this helps. Have you cleared the original codes?
