0
wow this is a tough one. you have to be careful and remember take your time. i had to change one in a 84 Mercury Grand Marquis - my car had a metal frame enclosing it . 1. remove the door panel 2. remove the trim piece that looks like a windshield wiper blade, it touches the window 3 remove the large door glass 4. there may be a screw on the door frame holding the little window in place remove it now remove the screw holding it to the inside of the door panel if you see a rivet instead drill it out. 5. drop the small window frame in the door and pull it out through the large window opening. your car may have a window gasket also holding in place pull this off. this is a very difficult job so take your time .
Wiki User
∙ 8y ago
Wiki User
∙ 8y agoTo install or remove the rear vent window on a 2001 Honda Civic you 1st have to take the rear door panel off. To remove the rear door panel you need to un-screw the screws hidden underneath the plastic door pull. The screws are not in the arm rest. Now you can pry the perimeter door panel fasteners off. Once the door panel is off, look for 2 (Gold colored) bolts. Follow the rear vent window channel downward with your eyes and you will see them. They are about 1 foot apart from each other. Before you loosen the bolts put the window in the up position. When you un-screw the lower bolt a long odd shaped washer is going to drop into the bottom of the door. Cut the plastic to get this washer. Your going to need it to re-install the vent channel. After you have the 2 bolts off follow the channel up this time all the way to the top of the door. Move the weatherstripping and you will see a small screw. Un-screw this screw and the channel will come out. Now you can install or remove the vent window.
Wiki User
∙ 14y agojust did that in my van 2000, you must remove the panel is very simple, then it screws you use dice and squeeze to get by adjusting the glass to their level, but it should be between two people, so that adjustments carefully. good luck.
Add your answer:
Earn +20 pts
How do you replace the rear vent window on a 2001 Chevy Blazer LS 4x4 2 door?
You can replace the rear vent window on a 2001 Chevy Blazer LS 4x4, 2 door with Direct Fit Power Window Regulators.
How do you stick the door windows of a 1966 Chevrolet truck to the track?
You need to remove the vent window assembly to remove and replace the door glass
How do you replace a quarter window 1995 Dodge caravan?
Do you mean the rear vent window?The sliding door,body side and quarter glass vent windows are done using same procedure.1.Remove upper trim moulding from around the glass. 2.Remove the screws holding llatch to glass.3. Separate glass from latch. 4. Remove nut covers and nuts holding glass hinge to window opening flange. 5. Separate glass from vehicle.
How do you replace a vent glass on a 2001 jetta?
Take it to a repair shop!
Will a 1968 camaro door fit a 1967 camaro if so what will have to be done?
The hinges are different on the 67 & 68 doors. 67 also has a vent glass, 68 does not have a vent glass. You can make it work, but it wll be a tuff job. Be better off to use the correct year door.
How do you replace door glass vw beetle?
Its not as hard as it sounds, but you have to take off the door panel first. Then you loosen the bolts for the window regulator. Then its just working the winow and out. On my 73 super beetle, I fond it easier to remove the small vent window also.
How do you do adjustment on door windows on 1967 mustang fastback?
i need to know how to do the adjustment on front windows of 1967 fast back mustang There are four points of adjustement for the door glass. Two are for the vent window, these two are used to adjust the vent window in or out and forward and back. There are two more for the door glass, these two adjust level and in or out. ::AverageJoeResto.com::
How do you close rear vent window on town and country?
drivers door has a switch for each window
How do you replace heater door control blazer?
The heater door control on a Blazer can be replaced by purchasing a new one. The heater vent will pop out with a little nudge from a flat tipped screw driver. Then insert the new heater vent door control.
How do you get out of the Bistro with the boss's glass on Spy island?
Climb up the inside of the kitchen vent, then across the light fixtures to the door.
How do you replace the PCV valve on a 1998 Mercury Mountaineer?
THERE ISNT ONE THERE IS A PCV VENT LOCATED AT THE REAR OF THE ENGINE
Were to place a vent on a door?
I can think of two reasons for cutting a vent into a door, temperature, or fresh air. Cut the vent in the upper door to vent heat or natural gas, in the lower door to vent cold or petroleum based gases, LPG, diesel fumes, ...
