answersLogoWhite
Pontiac Grand Prix

How do you replace the water pump on a 1988 Pontiac Grand Prix?


Top Answer
User Avatar
Wiki User
2011-09-12 21:05:55
2011-09-12 21:05:55

first you wanna drain cooling system of course, you need to remove the four bolts off the water pump pully, it's better to loosen them up when the belt is still on.Then remove serp. belt by using a regular 3\8 rachet on the tensioner. Remove the water pump pully.Then with a paint stick mark where the position of the pump is because you can move the pump to any position but it will only blot up one way.Remove the five water pump bolts,(they are 8mm bolts) then remove water pump.

Related Questions

User Avatar

no, you do not need a compression tool to remove or replace them

User Avatar

How do you replace the alternator on a 1988 Pontiac Fiero

User Avatar

No, Pontiac only offered a cassette player and AM/FM radio in 1988.

User Avatar

The Pontiac grand prix became front wheel drive in 1988-present. Before '88 it was rear wheel drive.

User Avatar

In a 1988 Pontiac Grand Am you will find the clutch slave cylinder located on the flywheel. You will need to remove the hush panel from the driver's side foot well to gain access to the clutch slave cylinder.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.