Water Pumps
Windshields and Wipers
Toyota Corolla

How do you replace the water pump on a 1989 Toyota Corolla?

808182

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 18:53:01
2015-07-15 18:53:01

The bad thing is you have to get in a really tight place. The motor is turned sideways as you know and you have to get to the water pumps an the side next to the passenger fender. You actually have to hoist the motor up to get the pump out. Dont take the motor all the way out just take the mounts loose and lift it at an angle and get to work.

If you remove the passenger side tire, then remove the plastic side splash guard you can access many of the bolts for the water pump from there.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


what is the firing order for a corolla 1984? The firing order for Toyota Corolla from 1984 to 1989 is 1,3,4,2.

Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.

TROUBLESHOTING FOR REPLACED STARTER IN TOYOTA COROLLA 1999.

Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.

The 1989 Toyota Corolla Weygand rear speakers can be found in the side compartments of the rear of the vehicle. There will be a speaker on each side.

The recommended tire size for the 1989 Toyota Corolla is 175 R70 13. However, a size larger can be used with no harm to the car.

Speedometer cable replace 1989 toyota

I want to know the wiring color codes of the Toyota corolla 2006 car radio.

When owning a car it is important to maintain the fluid levels. A 1989 Toyota Corolla uses 1 quart of Universal ATF transmission fluid.

The 1989 Toyota Corolla tail light relay switch can be found in the fuse box. The tail light relay switch will be in the third column, second from the top.

The 1989 Toyota Corolla serpentine belt can be tightened or loosen with the tensioner pulley. Pry to the left on the tensioner pulley until the belt is tight. Tighten the tensioner pulley.

Toyota corolla ignition coil can be found inside the distributor assembly together with igniter circuit... engine is 16valve carburator type..

Check the brake light switch located under the 1989 Toyota Corolla. If the switch is stuck the parking light will continue to stay on.

by your clutch pedal but far left attached to your inere wheel well

My Toyota corola 1.6gl 1989mod 16valve, lost the idling. wat can i do to fix it?

When changing belts, it is important to know the layout and have a diagram to help guide the removal and replacement of these belts. A diagram for these belts can be found in the maintenance manual of a 1989 Toyota Corolla 4-A-F.

how do you change out the left back door window in a 1989 Toyota corolla?

A Toyota Corolla CS 1.6L Manual Sedan has a 13-gallon fuel tank.

Well, first you'll have to re-engineer the vehicle to use a transmission belt.....

No, it has a timing belt which must be changed every 60,000 miles.

Endonde se encuetra el tapon para rellenar la transmicion estandar de una camioneta Toyota corolla all trac 1989?


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.