You will need to drive your front wheels up onto a stand to make the water pump accesible. Follow the large hose from the bottom of the radiator which goes to into the thermostat. The thermostat is connected to the water pump. You will have to remove the oil filter housing (3bolts) in order to get the water pump off. (watchout for the hot fluids....drain the radiator first.
There is no cabin ari filter on a 1991 Totyota Previa
replace the bulbs
The location for the idle switch of a 1992 Toyota Previa mini van can be found in the Toyota Previa Auto Repair Manual 1991 thru 1995. This can be purchased from the Toyota dealership.
it weights 5.410 pds
it has a 2.4li engine size for gasoline
I CHANGE MY OWN OIL IN MY 1991 PREVIA. 5W30 IS WHAT I HAVE USED FOR YEARS. PREVIA JUST PASSED THE 334,000 KM MARK
On the panel I think it says radio
Jack location for Toyota PreviaToyota Previa jack and tire iron are located under front passenger seat. Access from front on door side. It is held down with a butterfly screw and/or rubber retaining band. Easy to get out.this is on most united state previa,most European made previa the jack are locate under the driver seat.
A diagram of a 1991 Toyota starter relay switch can be obtained from most Toyota dealerships. The starter relay diagram can also be found at most auto-parts stores.
underneath , empty water , the bottom hose runs into a metal casing 2 nuts just undo it put thermostat the right way in and make sure the little lags match up , refill water and antifreeze , let it run for 10mins then check water again
Look underneth right beside the shaft going to the front
Under the dash behind the cruise control actuator, or so I have read.
you will need a new thermostat to cure this problem. ian
Try and get someone to read the ECU codes, that will tell you if the problem is from the "Knock Sensor". If it is you will need to buy a new one and replace it. They are very expensive and can only be got from a Toyota Dealer. To fit your self Drill a hole under the front seat(Directly above the sensor) and replace from there. If you dont want to drill a hole you will have to drop the engine and that is not a cheap option on a previa.
If you have 15" inch rims, the default factory tire size is p215/70.
most cars have a separate reservoir and pump for the rear, but I am not sure about the Previa I have one and i keep fillimg mine and seems to be ok for rear hope this helps
If its shorting or open, then YES
Sensa trac sells for 65 a piece with lifetime warranty
Would have been built for R12, can be converted to R134a.
Turn the key to acc. and push the plunger in located on the Ignition lock housing
changing the water pump is quite involved. I recommend a manual. The BGB is expensive, but is well worth it.
Depends who does it. It could take upto 3 hours of labour and struts start around £65 for gas replacements. Oil filled struts are better but dearer.