I replaced my water pump about 6 months ago.... I think I remember most of it. I have the 3.3 liter six engine. My water pump sits just under the A/C compressor. First, loosen the hose connection at the water pump and drain coolant into a container... you should be able to reuse it later. Remove/ loosen serpentine belt. Remove pulley from front of water pump... 3 bolts. Remove old water pump by removing the bolts that hold it on... three bolts, I think. The problem that I had was that 2 of the bolts snapped/twisted off ... the bolt heads came off with the threaded shaft rusted or siezed inside the engine block. Apparently the engine designers didn't do a very good job here... wrong type of metal and way undersized! If that happens you might want to ask for professional help. I ended up drilling new holes and using bolts/tek screws but your application may be different. Anyways, installation is just the reverse of removal... not bad if everything goes well. Good luck! Gary from Princeton, Minnesota
follow radiator hose unscrew the to bolts and it will be inside
I found a price at my local Auto Zone place for 69.99 plus tradein for one
In the fuse box.
the water pump is on the bottom of the engine underneath the alternator
The 1992 Dynasty came in either dark metallic blue or light metallic blue
i want the diagram for installing a fanbelt
you hump it you cut it
diagram for serpintine belt 92 dynastry
The water pump is driven by the pulley and serpentine belt on the left side of the engine. You'll need to remove the water pump pulley to access the water pump housing bolts. You may need to remove other pulleys to access the bolts. Replace the water pump gasket to prevent leaks.
Yes
as long as the marker lights are the same ( some years don't have them ) i not sure which ones , Chrysler made all the dynasty bodies the same , you should be able to interchange most of them.
The 3 speed is called an A413. The 4 speed is called an A604.