Water Pumps
Dodge Durango
Mitsubishi Eclipse

How do you replace the water pump on a 1995 Mitsubishi Eclipse GS 2.0L 16 valve?

858687

Top Answer
User Avatar
Wiki User
2015-07-16 19:30:27
2015-07-16 19:30:27

left front engine up, take timing belt cover off. Remove timing belt. remove bolts from water pump. but new water pump on. Set timing belt in the same position. But the timing belt and the pullies back on. Then your Finished.

Looking at the repair manual this is a lot harder than it sounds because, u have to remove the motor mount to remove timing belt.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Close the sun roof of the 1997 Mitsubishi Eclipse and spray water on the outside of it. Carefully look on the inside to see where the water is coming in. Then reattach or replace the gaskets as needed where the water is coming in to fix the leak.

User Avatar

drain the coolent remove timing belt.....loosen bolts....4g63, take off accessory belts and remove

User Avatar

You need to remove the timing belt cover in order to gain access to it. If you want to replace it, timing belt has to be removed too.

User Avatar

Personally I replace water pipe after I shut of the supply valve

User Avatar

Isolate it from the water supply then replace the defective valve

User Avatar

By shutting off the water supply and replacing the valve

User Avatar

You turn off the water valve before it -probably on the sidewalk, or just on your front yard. Then remove the main valve and replace it. NOT a job for amateurs. I hope you have some experience at least.

User Avatar

There are several things that can cause your 1992 Mitsubishi Eclipse to overheat. A malfunctioning water pump or a blown head gasket should be the next things that are checked.

User Avatar

If you go to autozone.com you can view repair guides online free.

User Avatar

When the pressure becomes erratic time to replace

User Avatar

Remove the water from the radiator. Remove the radiator hoses. Remove the stabilizing arm from the top of the radiator. Remove the radiator retaining bolts. Reverse the process to install the new radiator.

User Avatar

There is a special website of eclipse fans where you can find answers to any questions you have about your car. See below.

User Avatar

no water should be coming out of the safety valve , only if water over a certain temp orthan creates a pressure if water coming out and water not steaming than replace valve

User Avatar

First check to see if the valve for the water supply is turned on. If that isn't the problem you may need to replace the tank water valve, they do wear out and are not that expensive or difficult to replace.

User Avatar

Consult the Service Manual at http://tearstone.com/eclipsefsm/00_starthere.pdf

User Avatar

A 1999 Dodge Ram does not have a water control valve.

User Avatar

It will cost about $60.00 to replace a hot water gasket valve on a boiler. This is if you do it yourself. If you hire a professional, they will charge you for labor and the ending cost will be much more.

User Avatar

Might Be Yr running out of oil, or water levels are low.

User Avatar

driver side of engine, has a double pulley on it with 4 10MM bolts. Remove the pulleys off of it, remove timing cover, remove belts, remove bolts in pump and replace. Dont forget to replace the O ring on the water pump pipe that does into it, this is overlooked and very important.

User Avatar

I was charged $464.00 and I thought that was a bit rich to replace a T&P Valve today 26/09/11


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.