answersLogoWhite
Water Pumps
Toyota Camry

How do you replace the water pump on a 1996 Toyota Camry 4 cylinder 2.2L?

116117118

Top Answer
User Avatar
Wiki User
2015-07-15 19:07:46
2015-07-15 19:07:46
4is it 4 or 6 cylinder ? It is a 4 cylinder
1

Related Questions

User Avatar

Answering "How do you replace the water pump on a 1994 Toyota Camry?"

User Avatar

how do you install a water pump on a 1992 toyota camry

User Avatar

I have a 1997 Toyota Camry. It is leaking anti-frezze. I need to replace the water pump. Do I have to remove and replace timing belts too?

User Avatar

how much does it cost to replace the timing belt in a 1998 Toyota sienna.

User Avatar

it makes it run rough and lose of power i recently had to put a new filter and drain the gas tank on my 1999 Toyota Camry becuz of water in the tank

User Avatar

On the 4 cylinder engine it is located in the water neck where the hose from the radiator goes on the passenger side of the engine.

User Avatar

It's recommended to change the water pump at the time when you replace the timing belt.

User Avatar

$200-400 + part price depending on where you are going to fix it.

User Avatar

No, you do not need. Just remove all bolts and pull it out. Make sure that you replace the water pump gasket.

User Avatar

Usually visually you cannot see it because it's inside of the hose next to the water pump.

User Avatar

It depends on which of them. The one for coolant is located in the water inlet. Ambient temperature sensor is located in the filter box.

User Avatar

I'm dealing with the same problem on my station wagon Camry 1989. Pep boys say have to order thru Dealer

User Avatar

draing radiator water from toyota camry1994

User Avatar

buy a repair manual,because you have to take a few things off to replace the water pump including the timing belt,which should also be replaced.gmjim

User Avatar

No Camry has ever had a v4 engine. There is a v6 and an inline 4 cylinder. The timing cover typically needs to be removed making it an ideal time to also replace the timing belt. this is a fairly complicated job and is often best left to a qualified technician.

User Avatar

In order to replace the water pump on a 1988 Toyota Camry v4, first remove the front timing belt cover as well as the motor mount on the passenger's side of the vehicle. In order to remove the mount, the engine must be supported. Before removing the timing belt, mark the camshaft and crankshaft for guidance during replacement. Remove the water pump, and apply new gaskets to the new water pump with a sealant. Install the new pump, then the hardware that had been removed in order to access the pump.

User Avatar

You are looking at a bill from $250 to up to $700 depending on garage, whether you are going to replace the water pump (you better) and so on.

User Avatar

You can find it in the water outlet.

User Avatar

It is located on the bottom of the radiator

User Avatar

You need to remove the timing belt before you even will able to access it. Thus, use the procedure how to change the timing belt, but without changing part. Replace the water pump, make sure that you replace the water pump gasket too.

User Avatar

Belt. Recommended replacement mileage: 90,000 miles. Do yorself a favor and replace the water pump at the same time.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.