The front spindle must be removed as the bearing is pressed in. Not a job for a beginner, but if you have some auto expertise, not too difficult...
The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.
170 ft-pd
$185.00 parts and labor front left side
There wasn't a 1991 Dodge Stratus.
I would have to guess it is a front wheel bearing. Does it pull to one side? Are your tries good - a bad tire could make a similar noize. It's a wheel bearing. Just replace one on my 2000 Stratus.
how do i find out if i have ABS on my front wheel bearing , on my 2000 dodge Dakota quad cab 2 wheel drive
Front is easy, just replace hub rear is pressed in
Under, on the drivers side front of engine. Not an easy one to replace.
No, a Stratus engine sits transverse, while the Intrepid sits front to back.
Struts
Behind the front motormount
left front fender, in front of tire