The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Not too hard....just awkward. Safety first, open the hood and disconnect battery ground strap. Working from the drivers side of the engine compartment, right at the top of the firewall there is a elipticle shaped hump extending from the middle of the car to the right inner fender area. the hump has two intergrated spring clip to hold down the cover CAREFULLY lift the clips enough to raise the cover. there is a thick weatherstripping to seal the hood near the windscreen pull it from either end straight up and until it is totally off. With the compartment cover loosened adjoining it is a another plastic piece held in place with simple slide off clips pull them off and the side cover and then the center cover exposing the motor and the linkage for the wipers. At the motor is a spring clip you just lift and slide off. Now pop off the linkage arm at the motor and swing out of the way. You see an armature attached to the motor shaft pop off the 2/3 "plastic cover with a thin knife blade or thin pointed scribe. Remove center screw and remove the armature assembly consisting of the top piece a thin metal tension clip. You can see the either 3 or 4 nuts that hold the wiper motor in place. Before removing them, reach under and unplug all electrical connections to the motor. Remove the nuts/washers holding the motor and the wiper motor will drop down and out. Do it backwards to install. Boy that was wordy, Huh? Good Luck
The wiper control module is located inside the wiper motor assembly.
It is on top of the wiper motor itself. it's intergral.
The wipers motor has a tendency to become filled with water and short out the internal computer board causing it to malfunction.
read owners manual for info
It is under the plastic cover right below windshield. YOu have to remove retaining clips.
The 1998 Ford Crown Victoria windshield wiper relay switch can be found on the firewall in the engine compartment. The windshield wiper relay switch will be on the passenger side of the firewall.
The 1998 Ford Crown Victoria takes 22" replacement windshield wiper blades on both sides front.
How to replace wiper motor on a 1998 montero sport mitsubishi
how do you replace rear wiper motor on a 1997 ford explorer
Remove the wiring harness from the wiper motor. Remove the windshield wiper arm from the wiper motor. Remove the wiper motor retaining screws. Reverse the process to install the new wiper motor.
how do you replace a wiper motor in a 2000 jetta?
where is the wiper motor on a 1996 Nissan Maxima GXE