Want this question answered?
Pound your 2002 Suzuki left front wheel studs out. You will need to pound in the new studs in the same manner that you removed the old studs.
You replace the wheel bearing hub assembly - it has studs, bearings and wheel speed sensor around $100 part
Front studs on a 1999 Honda Accord are pressed in. First the studs must be removed using a hammer or press. Once remove each stud can be pressed in.
I belive they are the knock out type take off wheel and drum heat studs on the back hit from front. to replace put new studs in and put back on tires.
Remove the brake drum, drive out he damaged studs from the front of the drum, press in the new ones from the back of the drum, reinstall the drum.
You need to get the rotor off to replace studs with new ones.
You have to remove the caliper and then the rotor and tap on the front of the stud with a hammer so that it slides out from the back.
You have to have the hub pressed out of the knuckle to replace the wheel studs.
How do you change front tire studs on a 1994 Seville sts
You're going to have to drop both front and rear manifold connections. Should be 3 studs in the front manifold & 3 in the rear. Replace both o ring gaskets while you're in there. If the nuts on the studs are corroded then you might want to take it in to get it done because if you break a stud you will have more problems and higher cost to repair it. If you have accessto a cutting torch heat up the manifold to remove the studs or heat up the nuts as not to break the studs.
you dont
do you want to remove the actual studs or remove the lug nuts? the lug nuts may have left hand thread which means they go clockwise to loosen if you mean remove actual studs, u need to remove wheel. the studs will knock out with a hammer. you will need to replace with new ones