answersLogoWhite

0


Best Answer

there should be three bolt on the side of the cap, remove them and make sure yoiu mark where your sp wires goes.If not LOUD BACK FIRE..........

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace your 1990 integra distributor cap?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the difference between the TD23U and the TD24U distributor on a 1990 Acura Integra?

hi peoples the answer is the disturbitor cap one number is 1342 and the other is 5432


Where is the distributor cap located in a 1990 Acura Integra?

on the passanger side of the valve cover......or it's that plastic thing with the 4 thick wires coming out of it


How do you remove the distributor rotor from a 1994 Acura Integra?

Remove the bolts that hold the distributor cap onto the distributor. Once this is off the rotor can be reached and replaced on a 1994 Acura Integra.


Firing order for the distributor cap of a Acura Integra?

1 3 4 2


How do you replace a camshaft sensor on a 1999 Tahoe?

The cam shaft position sensor is located under the distributor cap. You can replace this easily by undoing the screws holding on the distributor cap, remove and replace the sensor, then just replace the distributor cap.


Do you have to remove the distributor to replace the ignition coil on 1990 Toyota Camry 4 cylinder?

No. The coil is the piece at the other end of the wire that comes out of the center of the distributor cap.


How do you replace distributor cap for 1993 buick century?

it is distributorless no cap to replace has coil packs


How do you replace the distributor cap and rotor on a 1998 Toyota RAV4?

there is no distributor on a 98 rav. therefore no cap or rotor. replace the plugs and wires and the tuneup is done


Distributor cap removal for 97 Chevy cavalier 2.2L?

how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.


Number 1 terminal on distributor cap for 1994 integra?

The easiest way to find it is to set #1 piston at TDC and see where the rotor is pointing, it should be pointing to number 1 terminal on the distributor cap.


If a 93 Integra won't start is it because of an electrical problem?

I had the same problem. Check all of your spark plugs, if they smell like gas they are burned out. You should replace your spark plugs and check your distibutor, not the distributor cap. If that turns out to be the problem replace the distributor, distributor cap, and the rotor. If you turn the key to start the car, but nothing happpens, the starter's bad. If the car turns over but doesn't fire up, then the igniter/coil in the distributor might have gone bad.


How do you install distributor cap if the screws are bad?

Replace the screws.