0
To replace the distributor cap on a 1990 Volvo 740, first disconnect the battery to ensure safety. Remove the screws or clips holding the distributor cap in place, then carefully lift it off. Note the position of the ignition wires before disconnecting them from the old cap, and then attach them to the corresponding terminals on the new cap. Finally, secure the new cap in place, reconnect the battery, and start the engine to ensure proper installation.
What else can I help you with?
How do you take a distributor rotor off Volvo 740 with turbo?
I'm trying to do a tuneup on my 89' 740 Volvo with turbo. Having problems getting the distributor rotor off?
Is there a rotor in the distributor on a 1988 Volvo 740 GLE?
Probably - remove distributor cap and look
How do you take a distributor off a Volvo 740 turbo?
to change the distributor on a 740 Volvo undo the 3 captive bolts that attach it to the back of the rocker box you will find it easiest to you use a short box spanner and yes it is awkard
How much does a 1990 Volvo GLE 740 weight?
about 3117 lbs
What is the bolt pattern for a 1990 Volvo 740?
5 X 108
How many airbags does a Volvo have?
depends on the year. my 740(1990) has none!
What type of oil is used in 1990 Volvo 740?
Volvo recommends 10w30 full synthetic oil.
What would cause 1990 Volvo 740 GL to stall while driving?
There are several things that can cause your 1990 Volvo 740 to stall while driving. The most common cause is a bad fuel pump.
How do i replace my ignition coil on my Volvo 740?
buy a new one
Where is the crankshaft position sensor on a 1988 Volvo 740?
in the distributor in the rear of the engine. sometimes known as a hall sensor
What is the firing order in Volvo 740 1990?
if its a 4 cylinder....1,3,4,2 if its a 6....1,6,3,5,2,4
Where can you find a diagram of a 1990 Volvo 740 vacuum system?
you can find it in a workshop manual
