Take the Positive and Negative leads off the batterys for about 2 minutes. Than reinstall, and blamo your back to normal, I know this to work from experience.
There is no "reset". If the light is on, the computer has detected a malfunction and set a code. The cause will need repaired, and the light will clear itself.There is no "reset". If the light is on, the computer has detected a malfunction and set a code. The cause will need repaired, and the light will clear itself.
what causes the light to come on
normally disconnecting one of your battery terminals and reconnecting it will reset the trouble light.
The light will reset itself when the malfunction detected by the computer is repaired. You need to have the system checked for codes.
The airbag light stays on when the computer has detected a malfunction and set a code. The light can not be reset until the failure is repaired.
After the Explorer is scanned for trouble codes to diagnose and then repair the malfunction , then the check engine light can be reset
There is no reset procedure for thesr lights , if there is a malfunction they will illumunate www.lextechautomotivellc.com
Over time it may reset itself. But the best thing to do is reset it with and OBD2 scan tool.
The airbag light can not be reset. The light stays on when a malfunction has been detected. You need to have the computer checked for codes and the failure repaired to get the light off.
There is no reset. Either the fluid is low, or there is a level sensor malfunction.
disconnect battery
you fix whatever is making it come on :-)