Want this question answered?
The airbag light stays on when the computer has detected a malfunction and set a code. The light can not be reset until the failure is repaired.
I Do not have jeep or one does not have an airbag
I have the same jeep and had the same problem its the clock spring thats broke you need to replace the steering colum or you can go and get the codes reset on it you can try to reset it your self disconnect your battery cables over night and it should reset your codes and your airbag light should go off mine did
what do you reset the cehck engine light patriot manual transmission 2008? thanks for you support.
obviously this is a very annoying problem with Jeep commanders. I've read other stories whereby you might need to purchase a reset module. My questions is, "Is this a money making scheme?" I'm a LITTLE weary of taking my Jeep to the dealers, paying them, and no results. My light stays on all the time and I tried the ignition reset idea with no results. My big question is, "Will the airbag deploy for no reason at all. If so, this can be a very expensive experience. The airbag light stays on when the computer detects a malfunction in the system. You have to have the system checked with a scan tool to know the code/codes and possible causes. When the cause of the code has been repaired, the light will reset itself.
How do you reset engine light on jeep liberty diesel
Jeep does not use inertia/reset switches.
The airbag light stays on when the computer has detected a malfunction and set a code. A scan tool is required to read the codes. The light can not be reset until the failure is repaired.
If the light is on, the computer has detected a malfunction. You will need to take in for service, so a qualified technician can repair cause of malfunction.
The airbag light stays on when the computer has detected a malfunction and set a code. You need to have the system checked for codes with a scan tool and repair the failure. The light can then be reset.
Key on engine off, press gas pedal to the floor three times, cycle key off ans on. Light should be reset.
The airbag light comes on at start up for a bulb check. It stays on when the computer detects a malfunction and sets a code.