Sorry I do not have an answer but I have the same year (2003) and need to reset my Ford Expedition door code as well. If you find out how please let me know. Thanks, Brett climiebrett@Yahoo.com
PS You are looking for a five to seven digit code printed on a "cream colored control module . that code gets entered into the door pad with the door shut
then press 1 then your new 5 digit code and the doors will lock and unlock to signal your new code is set. the factory code still works.
ahh life is good !
my best answer
also look at this link to see other tips on how to enter the codes desired. http://autoforum.classifieds1000.com/Ford-Expedition/keypad_keyless_entry_code
and this link also adds flavor to the ford keypad possibilities: http://where-is-the-ford-keypad-instructions.blogspot.com/
Oh My... I almost wet myself it was so simple.. Thank you greatly for saving me 45 dollars(plus tax, plus gas to get there), here at the local ford garage in Appleton WI. Fellers and Ladies... I own a 2001 Expedition Eddie Bauer Edition...( and yes I am happy I bought it. ) and yes it was so simple... I found my "cream colored" computer control module on the driver side up and under the dash near my "left foot". The basic dimensions of said module were about 1 1/4 inches deep by about 3 1/2 inches square (or close, might have been a rectangle) The five digit number which was the most "Bold" and biggest font on the module was the number needed for me...( IE: it was also in the middle of all the writing.) Note. i removed nothing... just looked in the dark with a flash light ... it is the easiest in the very dark, not daylight to see into those kinds of corners/ crannies etc. best to you... yer da besht !!! (acting yooper accent)
how do you get the entry codes for expedition eddie bower
Each vehicle with keyless entry has it's own factory code
Where do I find the key less entry code on a 2001 Ford Expedition?
on my 2003 expedition the code is located behind the access panel on the passenger side floor board where the fuse box is it is a 5 digit number.
dont need the current code...under drivers side dash. you will have to basically lay down in the floor. you will see a sticker with the factory code. you will have to use that to reset the door code. those instructions will be in your owners manual.
how do you clear a P1000 code on a 2003 ford expedition
Each 2001 Ford Expedition with key less entry has it's own factory code
Answer 2003 expedition keyless entry locon my Eddie Bauer edition, its behind the glove box. Pull in the tabs on the side of the glove box & let the glove box drop down. In behind all the wires on the right side is a black box with a sticker on it with 5 numbers on it.This is your keyless entry code. P.S. You'll need a flashlite. JH
The keyless entry code is located below the driver window on the exterior
Door Code Location...I actually found the door code behind the fuse box area (Driver Side) on my brother's 2000 Ford Expedition EB. There is a big white sticker with 5 numbers starting with number 1####. Hope this helps...
Where would I find the factory key code location on a 2003 Expedition?
The proper way is to take the vehicle to the dealership. There they will reset the code.