The waterproof error message means that there is water in the base of the dishwasher. The anti-flood float switch in the base went up and the machine is now inoperative.
re-start car 3 times in 90 secs
First the light has to be connected to a tester to erase the fault codes. Then it should be programmed to get the new codes and it works.
The ABS light is on because there is a fault in the system. Once the fault is repaired or fixed the light will reset itself. The ABS system can be scanned for codes to help diagnose the problem.
There is no reset for the computer. You can disconnect the negative battery cable for 5 minutes and this may or may not reset any fault codes. If not they will have to be reset with an OBD2 scan tool.
You get the software for the engine (e.g., DDEC for Detroit, Insite for Cummins, and I'm drawing a blank remembering what it is for Cat) and a diagnostic connector (such as NexIQ or Inline for Cummins), pull up the fault codes, and reset them. Now, if it's something which is going to be recurring, those codes will come back until you repair the fault (if they clear at all).
No there isn't.
Repair the component that set the fault code, and then reset the ECU with an OBD2 scan tool.
I believe you can unhook the battery and let it sit for about 5 minutes before hooking it back up. Otherwise you need a VAGscanner to reset the fault codes.
you will need to plug in an obd diagnostic scanner to read the fault codes then clear them which will turn off the light
You can reset codes with a scan tool or by unhooking the battery.
reset
I found my own answer on your web site. The answer is to press the "trip and reset" buttons at same time and then turn on the ignition switch to the run position and hold for 5 seconds and then press trip button.I also found fault codes I think.