Adjust tire pressure to the proper specs on all tires and take it for a short drive. It will reset before you get down the street. If it doesn't reset you have a problem with one of the tire pressure sensors.
Adjust tire pressure and drive it. The light should reset itself after a short drive unless the pressure sensor unit in one of the tires is bad.
reset the average mpg reading
The light turns itself off if all tires are at the proper pressure (36 psi) and there are no sensor faults. If the light stays on, you will need to have the system checked for codes by someone with a scan tool.
It will reset itself in a few miles once you have ample pressure in tire
How can I reset engine light on renault master van 2012 125bhp
To reset the oil change light on a Toyota Highlander 2012, switch the engine to the OFF position. Then switch the engine back on while pressing the trip meter reset button until it displays 000000 or says COMPLETE.
The airbag light stays on when the computer detects a malfunction and sets a code. It cannot be reset until the failure has been repaired.
Tire pressure warning light.
The change oil light is reset by turning the key on, engine off, and pressing the gas pedal three times.The check engine light can only be reset with a scan tool. The cause of the fault needs repaired or the light will return.
The airbag light is on because the airbag module detects a problem with the system. Fix the problem and the light will go out by itself.
Have vehicle scanned at auto parts store to determine problem and repair
Reset - 2012 VI was released on: USA: 1 July 2012 (limited)