how do i reset the check engine light on a 1999 acura 3.2tl
Resetting the maintenance light on a 1999 Toyota Tacoma is very easy to do. To reset the light, take the battery cables off for up to one minute to reset the light.
Check out G20.net
remove the alternator fuse for 20 seconds.
check engine light reset on a 1999 Acura CL 3.0.. Just replaced the egr valve. Thx
Resetting the maintenance light on a 1999 Nissan Altima requires access to the engine compartment of the vehicle. Once their locate the battery and disconnect the negative cable for 5 seconds. Doing so will allow the system to reset.
With the ignition switch in the off position, hold in the hold in the trip odometer. Now turn on your key and you will see a series of zeros begin to appear. Once that stops, your maintenance light will be reset.
you can reset it by disconnecing the battery for 1 hour then drive it for 10 to 20 miles and as long as there is no problems then it will stay out.
you should be able to just disconnect the battery for about 15 minutes and then connect it back up and it should make the light reset and go off. It worked for me at least
Under the hood, in the fuse block, there is a little red button. Turn on the key (but don't start the engine) and then hold down the little red button for 5 whole seconds. Poke your head in the door to see that the maintenance light is flashing. This confirms that the oil life monitor was reset.
how do I reset my service engine light on my 1999 ford f150
There is nothing to "reset" for the 1999 VW Beetle.