Want this question answered?
how do you reset engine light on 1991 volvo 240
reset the brakelamp light on the dashboard - Honda prelude 1991
To reset "CHANGE OIL" light, turn the ignition switch to the run position without starting the engine. Fully depress and release the accelerator pedal 3 times within 5 seconds
How do you reset the check engine light on a 1991 mercedes Benz 560 Sel
To reset the service CCR light on a 1991 Eldorado, disconnect the battery for 10 minutes. Reconnect it and start the car.
When "CHANGE OIL SOON" light is illuminated, find the hole in the underside of the dash on the passenger side near the door. Insert a blunt instrument into the hole and press the switch. The light will flash four times when the system is reset.
There is no reset for a check gauges light. If the light is on, there is a problem either with the temperature oil pressure or voltage.
The maintenance light on all early model hondas have three stages. Green, orange and then red. This light only serves as a reminder to change your oil, air filter and to do other routine maintenance. If you were to service the vehicle and not reset the light it would just stay on. It changes color by miles. It's green when it is reset and as you drive it will eventually change to orange and then red regardless of any services done to the vehicle. To reset look on the instrument panel for a slot near the light and insert your key this will change it back to green.
Because you need to reset the light after you change the oil. Changing the oil doesn´t turn off the light automatically , you need to reset it. there is a very small push button on the dash board that has a label "RESET OIL CHANGE", with the engine off, push and keep pushing while you turn the key to power up the accesories but don´t turn the engine on. the light will go off after a second or so. Because you need to reset the light after you change the oil. Changing the oil doesn´t turn off the light automatically , you need to reset it. there is a very small push button on the dash board that has a label "RESET OIL CHANGE", with the engine off, push and keep pushing while you turn the key to power up the accesories but don´t turn the engine on. the light will go off after a second or so.
Have vehicle scanned to determine the problem
Look in the e38 forum and it will give you a detailed account of how to do itType your answer here...
Disconnect the battery for about 1 min.