How to Reset the Change Engine Oil Message
The Aztek uses the GM Oil Life System to calculate when to change your engine oil and
filter based on vehicle use. It is widely thought to determine oil life by counting engine
revolutions. While there is much debate about the merits of such a system as a basis for
determining when to change engine oil, the system should be reset after each oil change
to ensure that the CHANGE ENGINE OIL message does not appear inappropriately.
There are two procedures for resetting the system, one for Aztek's with a DIC (Driver
Information Center) and one for Aztek's without a DIC.
PROCEDURE 1: Aztek's with a DIC
1. Turn the ignition to ON with the engine off.
2. Press the MODE button until the DIC reads "OIL LIFE LEFT/HOLD SET TO
RESET"
3. Press and hold the SET button until 100% is displayed.
You will hear three chimes and the CHANGE ENGINE OIL message (if illuminated)
will go off. Repeat this procedure if the CHANGE ENGINE OIL message comes back
on.
PROCEDURE 2: Aztek's without a DIC
1. Turn the ignition to ON with the engine off.
2. Fully push and release the accelerator pedal slowly three times within five seconds.
3. Turn the key to OFF.
If the CHANGE ENGINE OIL message continues to be illuminated, repeat the
procedure.
how to reset the airsuspension on the 2004 Lincoln navigator
How do you reset the 'oil change required' message on 2007 Lincoln Town Car???
como resetear air suspension off lincoln navigator 2008
where is the reset switch for air compressor for Lincoln navigator 2003 on the left side all way to the back is a small compartment, right there you can find the fuel reset switch and the air compressor reset switch
can't be heard on the voice recognition
unplug the unit from its harness for a few
Disconnect positive terminal on battery leave off for 1 minute then reconnect this should reboot your computer chip
In the front passenger footwell by the kick panel
advance auto or OB II code reader
Check Owner's Manual. If you do not have one. Check Related links below.
Follow the instructions on page 85 of the owner's guide that comes with the vehicle.
There is a switch on the side wall up behind the glovebox. It's a rocker switch.