Turn the Ing. key on and pump the gas padel all the way to the floor
3 times. then turn key off then start engine.
There is no filter.
It is the electronic part at the base of the accelerator pedal itself.
is it difficult to change the fuel sensor on a 2007 Chevy Malibu
The TPS sensor is mounted on the throttle shaft on the opposite end of where the cable attaches.
How do you reset the 'oil change required' message on 2007 Lincoln Town Car???
It is the electronic part at the base of the accelerator pedal itself.
dealer only you can enter the resset mode but you need the sensor to go at each wheel to finish reset
You don't need to. It works or it's broken.
what are the colors of the wires of the IAT/MAF for a Chevy silverado 2007 1500 4.8L
on my '03 silverado i turn the ignition key to run position and press the gas pedal to the floor three times then turn the key off. the next time i turn it on it says oil change cycle has been reset. give it a try.
To reset the oil change lamp on a 2007 Town and Country, locate the reset button on the instrument panel. Hold the button down for 5 seconds.
most stock sensors are supposed to read up to 65psi, but most don't . If u put 22's on your truck, u need to buy a new sensor ( dealer part only). U could always disable it if that feature is not necessary to you