Hey- I have the same question. I bought this 96 Cherokee and it has it's issues. I have no remote for the door locks and everytime I lock the doors I have to unlock the hatch before unlocking the other doors, otherwise the alarm will go off until I unlock the hatch. Now it has a new issue; twice this week the alarm has gone off. Once at 4am and the next time at 3am. It is not impossible that someone could have messed with my Jeep...twice in a week...without success....but it is unlikely. However, it seemes just as unlikely that the alarm system is failing, while I am out of town and twice in a week and both at wee hours in the morning!?!? Any thoughts?? jenifre gmail.com
Under the back seat driver side is wiring harness with a purple wire with a yellow stripe. Ground this wire and it it will bypass the alarm system (horn will honk 3 times)and let you start your car. I have not ungrounded my yet.
Close all doors and then insert your key on the door handle. lock it then unlock it as if you did not have a keyless entry system. then try it. I hope it works!
you could discect the batter or remove the fuses one by one on the eletrical pannel
turning key in the door lock should disengage the alarm
i need to disable jeep factory alarm 1997 cherokee
if you have a factory alarm..you will need a power remote to reset the alarm. or you can reset the alarm be using the key in any of the door locks or in the rear hatch lock . just cycle the key to the unlock position to shut alarm off. to reset alarm to armed use the door lock power switch to lock the door then shut door and alarm will reset to on .
How do you change the orifice tube on 1997 grand Cherokee jeep with 5.2 v/8
It will bolt up, but it will not shift. 1997 is electric, 1994 is hydraulic
Disconnect the alarm horn !
i need to disable jeep factory alarm 1997 cherokee
Chrysler does not have reset buttons. The factory alarm is reset by unlocking the doors with a key or remote.
if you have a factory alarm..you will need a power remote to reset the alarm. or you can reset the alarm be using the key in any of the door locks or in the rear hatch lock . just cycle the key to the unlock position to shut alarm off. to reset alarm to armed use the door lock power switch to lock the door then shut door and alarm will reset to on .
The factory alarm is part of the engine and body computers. It can not be disabled. It is reset by unlocking the doors with a key or remote.
The factory alarm can not be disabled. It can only be reset by unlocking the doors with the key or use the remote.
The factory alarm can not be disabled. It is part of the engine and body computers. The alarm is reset by unlocking the doors with a key or remote.
try disconnecting the battery for maybe 10-30 minutes...that should work.
go to allexperts.com they will help you on this
The correct factory tire size for a 1997 Jeep Cherokee is 225/75-15.
my 1995 Saturn sl2 has a factory alarm, my daughters 1997 sc1 also has one
Normally, putting the key in the drivers side door lock,turning to the left, then to the right all the waywill unlock and disarm/reset the "OEM factory"alarm system.
Disable, no.