answersLogoWhite

0


Best Answer

Put the key in. Turn it to position two.(where all the dash board lights come on, dont start the car) Leave the key in that position for 45 seconds. The fault should clear provided your sensor circuits are complete.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reset the Brake pad sensor light on a Range Rover?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Replacing brake pads in a 2006 range rover sport HSE?

HOW DO I RESET THE PAD WARNING LIGHT ON MY RANGE ROVER


How do you reset brake lights on for 2003 land rover range rover?

THIS VEHICLE THROWS A CODE WHEN ELECTRONIC WEAR SENSOR HITS ROTOR, CAUSING MESSAGE "CHECK BRAKE LINING", AND BRAKE LIGHT TO COME ON. THIS CODE MUST BE CLEARED IN VEHICLES COMPUTER BY OBD II OR EQUIV.


Your red light for the abs ystem stays on rover 1998 vi?

Check your brake fluid. You may need to replace a speed sensor on one of the brake assemblies.


How do you reset the service light on a supercharged range rover?

range rover supercharge service light off


Why is the abs light staying on range rover p38?

the abs sensor on the disk in long periods of dry weather builds up dust which gives a false reading that brake failure is to blame but it is not the case just dust of your plates.


How do you get at brake light bulb on rover 25?

put it in .. der


What is wrong when you rear abs and brake light sensor stays on in your 1995 rodeo?

you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor


ABS and Brake warning light on?

The ABS and brake warning lights will come on in a vehicle when an error is detecting in the he system. This can range from low fluid or pressure to sensor and component failure.


What would a Rover 75 warning light with a yellow circle and dashes round it be?

It's low break pads. you have to check the brake pads and need to be services. please note that it come with break sensor. to remove the light u may required to change the brake sensors


Brake light is on but not working properly when you step on the brake. Where you can find the tail light fuse 1998 land rover?

If I understand your post: The brake light is on constantly? If so, you may want to adjust or replace the brake light switch located at the top of the brake pedal.


Why is the brake light on in a 1999 grand am?

Check the sensor on the brake pedal arm.


Where to download a free owners manual for a 2006 Land Rover Range Rover?

On the dash board above the gas gauge what does a (!) light coming on mean on a range rover 2006 sport?