you can disconect the battery for a minute to 5 minutes, if that dosent work you havent fixed the problem.
unhook both battery cables for a few minutes
Just unplug the negative terminal of the battery for about 10 minutes and that will reset the computer
The computer will reset itself after a few driving cycles. To reset the Check Engine light you can try this. Disconnect the positive battery cable for 20 minutes. If that does not work you will need an OBD2 scan tool to reset the light. Go to the place where you bought the O2 sensor and ask them to reset the light. Some will and some won't.
Remove the negative power line to the battery. Wait a few seconds and replace. That will reset the check engine light. darksidesteve
disconnect the negative battery cable for 30 seconds
Reset light when replacing headlight
THE CHEAP WAY.... DISCONNECT THE BATTERY FOR A MINUTE OR SO. JOSE
Why would you need to reset the Powertrain control module (PCM)???Are you asking how do you clear the CHECK ENGINE LIGHT??
hi how do i reset tire pressure sensor light on
how to reset the batterie light
Because after you change a sensor you have to hook a OBD I or II to your computer's wire harness to clear the code. Or you can turn the backwards and then forwards and sometimes that will reset it. Either way changing the sensor won't reset the check engine light...U have to clear it thur your computer.
It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.