answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2012-03-17 21:39:34
2012-03-17 21:39:34

i have a 98 Ford Expedition XLT the remote does not work how do i reset the alarm so it will work

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


To unhook a factory alarm system look for the alarm brain on the dash and Cut the two red and blue wires. Reconnect the wires and the alarm will be reset it self.


In the front passenger footwell by the kick panel



As far as I know , you inflate the tire(s) to the correct pressure and then drive the vehicle


There is a small hole on the underneath side of the rearview mirror. You have to use a paperclip to push the reset button inside and turn the vehicle in slow, short circles until it resets.


My Explorer won't turn over; the lights come on and attempted to jump the vehicle. Where is the fuel bottom if engine does not turn over?


how do you get the entry codes for expedition eddie bower


Unfortunately There is not a reset oil button ( Like the explorer) at least for the 2003 Expedition ( Eddie Bower model)


Auto Zone will read your codes FREE. They will tell you what is causing them to come on. This way you can fix your problem without having to guess. They will or can reset your codes if you ask them too.


In the right front passenger footwell , by the kick panel


It should be on the keyless entry control module behind the fuse box (below steering column) on the firewall. It's a five digit number 1xxxx.


In the right front passenger footwell , by the kick panel


In the right front passengers footwell , by ( or behind ) the kick panel


How do you reset the alarm for a Ford Laser


The alarm is reset with the remote or by unlocking the door with the key.The alarm is reset with the remote or by unlocking the door with the key.


The alarm is reset by unlocking the doors with a key or the remote.The alarm is reset by unlocking the doors with a key or the remote.



To reset an alarm system on a 2005 Honda Civic locate the brain. The brain should have a reset button located on it. Press it to reset the alarm.


how to reset hornet alarm,, cause my car can't start..alarm still active,,


To reset the alarm on a Volvo S90 you will need the key alarm. Press the lock button on the key alarm. Next press the large button the key alarm. The flashes that you see on the LED is confirmation that the alarm has been reset.


The factory alarm does not have a reset button. An aftermarket alarm may have a reset. It could be located wherever the installer put it.


Try disconnecting the battery. Let it sit for a few minutes and reconnect. This will reset your computer.


how to reset the computer on a 1997 ford expedition


unlock the doors manually and it should reset your alarm.


How do you Reset the alarm on a 1998 Camaro Z28? If I set the alarm it will go off moments later. I was hoping a reset would fix this issue.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.