I know the secret and know its pretty easy , hold down the top and bottom four approximatley four seconds , you will hear the heater system run a diagnostic from cold to hot wait for lights to stop blinking realease bottons if this fails you have a problem within the system ancient Chinese secret pass it on !
The check engine light on a 2000 Plymouth Grand Voyager will come on when an error is detected by the vehicle's computer. The cause can range from low oil to mechanical problems or incorrect timing.
The airbag computer has detected a malfunction and set a code.
Defective computer these vans are known for this
Just above the brake pedal. The switch sets against the arm of the pedal.
how do you reset change oil light on chrysler grand voyager minivan 1997
Look behind the door handle pocket and the light or reflector on the panel.
Bad bulbs they are double filament or Bad stop light fuse or bad stop light switch
The sender is in the tank and something is wrong with it. It probably needs a new sending unit.
i had the same problem i just cut one of the wires leading to the switch that was causing the problem
The door being open.
The problem is most likely the clockspring. Go to this link it will tell you what to do. http://www.automotive.com/1997/49/plymouth/voyager/recalls/38659.html
it is a warning light of course
The maintenance required light requires a scan tool to be reset.
An ignition misfire has been detected
the reverse light switch is usually mounted on the shifter inside the car.
ITS HARD TO TELL THE SPECIFIC REASON A WARNING LIGHT LIGHTS UP ON A VEHICLE WITH OUT CHECKING IT, BUT A BLINKING LIGHT USUALLY MEANS HAVE CHECK ASAP. A STEADY LIGHT MEANS HAVE IT CHECK AT YOUR CONVINIENCE.
2 screws, up/down. left/right
A flashing check engine light is an indication of a misfire.
A turn signal indicator can be replaced by first removing the burnt out light inside of the glass chassis. The new bulb will then be installed in the same fashion.
yes... It could also be the oil sending unit or the oil pressure switch.
The plastic is melted on the back of the light wear the two metal touches
i had the exact same problem with our 91 voyager, i cleaned the battery terminals and the problem went away immediately
Yes, that is possible.
unhook - side of the battery and let set 5 mins and reconnect and the light will go out.
it is screwed into the side of the transmission on the front side of the van.