close all of the door then lock and unlock them>alarm should stop nd car should start
to reset the alarm system for a Mercury Sable when the alarm is causing the car not to start, place the key in the ignition. Turn the key only about halfway and leave it in this spot for 10 minutes before trying to start the car.
in my past experience in alarms there should be a button hidden under the dash in your car The factory alarm is reset by turning the key in either front door or the liftgate.
how to reset hornet alarm,, cause my car can't start..alarm still active,,
have you tried disconnecting the battery then reconnecting? HI, according to the owners manual; the alarm system will only allow the vehicle to start if the operator opens the doors with the key. Don't know if this will work though
The factory alarm causing the issue would be the security light flashing above the RPM guage. If the security light is flashing and the car will not start, follow the directions listed below. To reset the factory alarm, turn the ignition switch to the "on" position NOT the start position for 15min. You will see the security light go off after 15min.
unplug the battery, this will reset the car with the alarm disabled
To turn off the alarm you hold down 'Reset' and press 'Start' Hope this helps!
Contact the dealer.
ok
To reset the alarm on a Corolla 1993, place they key in the ignition and turn it until it clicks. Keep the key in this position for 10 minutes and then start the car as normal.
Hold down reset, then press start, the alarm bell symbol should dissappear.
Turn the ignition switch to the auxiliary position. Do not start the engine. Leave the ignition switch in the auxiliary position for 30 seconds. This will reset your alarm system.