Try ignition in "on" position engine not running accelerator to the floor 6 times On the dash there are 2 buttons one says mode the other says set. Press mode until you get to oil life ten hold down set until it resets.
In most cases, yes. But it will require the correct computer and wiring to run the throttle body.
WHAT is the easiest way to change the oil pan
ok more air flow....did you change to a larger throttle body?
take it to the crusher
Could just be throttle plate sticking--without engine running try to free with a screwdriver Could just be throttle plate sticking--without engine running try to free with a screwdriver
The 3.8L engine found in some years and models of Buick cars uses a throttle body to regulate the amount of air flowing into the engine. This throttle body has a butterfly valve on the front which is opened and closed with the throttle cable. The throttle body needs occasional maintenance, including cleaning and lubricating the linkage. To do this, you can remove the throttle body from the engine, which should take about an hour to do.
The coolant temp sensor is located at the thermostat housing... can see it between the driver side front engine mount and the throttle body. It is a 2-wire connector
The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.
loping is when your engine raises and lowers rpms on its own without touching the throttle
The coolant temp sensor is located at the thermostat housing... can see it between the driver side front engine mount and the throttle body. It is a 2-wire connector
It would depend on what the problem is. All throttle problems can lead to a non running engine.
Throttle linkage between control handle and carburetor is loose or broken.