The vehicle's ECM (Electronic Control Module) performs a self diagnostic and resets itself automatically when the battery cables are reconnected. It does this same routine each and every time the negative cable is removed from the battery prior to doing any electrical work on the vehicle. Just put in a new battery, attach the cables and you're good to go.
Yes, you do... But if you do within 1-2 minutes you might not reset the computer.
You do not have to reset the computer any more than you reset your computer in your home after a power outage. It will take care of itself.
Disconnect the battery for a few moments. When it is reconnected, the computer should have reset. if this method is not successful then the car will need to be taken to an authorized dealer to be reset.
You need to disconnect the battery for about 5 minutes.
do you have to reset computer after changing battery in 2003 745li
There is nothing to reset. The computer will function normally when you connect the battery again.
Disconnect the battery for 5 minutes or use an error code reader to erase the computer to the default configuration.
You do not have to reset the computer.
To reset computer on dodge caliber. remove the dodge caliber, remove the negative and positive cable from the battery. You can then reset your computer.
You have to disconnect the battery for couple minutes.
To reset the computer on a 1992 Oldsmobile Cutlass Supreme, unhook the battery for about five minutes. Then reconnect the battery. If this does not work, look for the reset button on the computer and manually reset it.
If you are sure that the all system is fine and does not need any service, you can reset the computer by disconnecting the battery for about 5-10 minutes. Or you can use of error code readers.