Usually can be done by unhooking the battery for 10 min or so.
v8 is 18436572 left bank has 1357
Any hood from an 82 to a 92 firebird,formula or trams am
To reset the computer in a 1992 Buick Roadmaster, you can disconnect the negative battery cable for about 15 minutes. This will clear any stored diagnostic trouble codes and reset the engine control module (ECM). After reconnecting the battery, you may need to drive the vehicle for a short distance to allow the ECM to re-learn its parameters. Always ensure you have any necessary radio codes or settings noted before disconnecting the battery.
It is located behind the passenger side kick panel.
The 1992 Chevrolet Astro Van ECM can be tested with a diagnostic tester. Most auto mechanic shops have diagnostic testers.
It does not have one.
You can reset a maintenance light on a 92 Lexus SC400 by disconnecting the battery. Leave it disconnected for 10 to 15 minutes.
scanners work for 96 vechicles or newer
the trunk...it will say ecm on it some but few are under the dash..
Remove the inside of the glove box and then look in to the bottom right side and you will see it.
No, Dodge does not use inertia/reset switches.
Gm vehicles do not use ineria/reset switches.