I had the engine light come on in my patrol due to overheating and I had to take the vehicle to the dealer's service centre where they plugged it into the computer which advised why the light came on and then reset it. There was a minimal service fee for this. I assume it will be the same process for the Mazda.
Reset the change oil light on Mazda 3
The "check engine light" on a Mazda three is located to the left lower side of the tachometer. It is orange in colour.
Put the proper amount of air into the tires.
Repair the problem and it will typically reset itself after 3 starting cycles.
Unplug the baterry, press brake for 20sec, done :)
take to o riely auto and have them run a diognostics check, they do it for free
To fix a Mazda 3 ABS light 05 plate from staying lit you will need to see a dealer. They will need to use their computer to reset the code as long as the ABS light is faulty and not the actual ABS system.
In order to fix or reset a Mazda 3 ABS light when it stays lit, you will need a scanner in order to determine which system is faulty. It can be as simple as a dirty sensor, or more complicated as a computer module. Once you determine the issue, you can then take the proper course of action to solve the problem.
Well i don't know but if you look in a car book you will find out
4cyl = Mazda BP engine v6 = KLZE engine
There are many reasons for that check engine light. You could go to dealership. Or you could simply disconnect battery and reconnect after 3 minutes.
Turn ignition switch on, press accelerator pedal to floor rapidly 3 times, start engine and light should go out. Do not press more then 3 times as then it will not reset.