0
turn the key to the "on" position without starting the engine then press the gas peddle to the floor three times this resets the computer, use this for coolant and oil changes etc.
Wiki User
∙ 14y ago
Anonymous
8
Add your answer:
Earn +20 pts
How do you reset low coolant light on 1999 Pontiac?
Refill the reservoir with coolant and the light should go out unless the switch is broken. Where is the temperature sensor for motor? one for computer
How do you reset oil change light on 1999 Chevy silverado 1500?
key on engine off press accelerator pedal to the floor five times very rapidly should reset
What type of coolant does a 1999 silverado use?
It should be the orange Dex Cool.
Fuel pump reset switch 1999 Silverado?
GM vehicles do not use inertia/reset switches
Where is the brake light switch on a 1999 Chevy Silverado?
what does it mean if my brake light is blinking on and off when its pushed down in my 1999 Chevy silverado
How do you reset a check engine light 1999 Acura 3.2 TL?
how do i reset the check engine light on a 1999 acura 3.2tl
How do you reset the maintenance light on a 1999 Tacoma?
Resetting the maintenance light on a 1999 Toyota Tacoma is very easy to do. To reset the light, take the battery cables off for up to one minute to reset the light.
Where is coolant temperature sensor on a 1999 silverado 4.3 engine?
beside the thermostat housing on top of the engine
Where is the radiator cap 1999 silverado?
there is no real radiator cap. On the left side of engine compartment there is a coolant jug. This where you would add coolant to radiator.
How do you reset maintenance light on 1999 acura t l 3.2?
How to reset maintenace light on 1999 acura t l 3.2
How do you reset service engine soon light on 1999 Ford F-150?
how do I reset my service engine light on my 1999 ford f150
How to reset low coolant light in 1999 Pontiac trans am?
First check coolant levels, if they are correct. Try disconnecting the battery ground connection for 5 minutes to clear the prom, then reconnect and start the car. If the light is still on, then the sensor is bad, and must be replaced.
