answersLogoWhite

0


Best Answer

== == On my 1998 Lesabre there is a button inside the glove compartment. To reset the oil light you simply hold the button down for a few seconds until the oil light flashes three times and goes out.

There is a black panel above the passenger feet that is rectangular. On the right hand side there is a small hole the size of a dime. put a pen or pencil in the hole with the ignition in the on position prior to starting. the oil light will flash three times and go out.

User Avatar

Wiki User

โˆ™ 2008-09-25 13:45:30
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reset the oil light on a 1998 Buick LeSabre?
Write your answer...
Submit
Related questions

Where is fuel shut off reset button on 1998 Buick LeSabre?

The fuel shut off reset button is located inside the 1998 Buick LeSabre. It can be found on the firewall in the front passenger side.


How to disconnect brake warning light and sound 1998 buick lesabre?

Cut the wire


Where is the solenoid on 1998 Buick lesabre?

The 1998 Buick LeSabre solenoid can be found on the firewall in the engine compartment. There will be three solenoids on the firewall.


How do you install a heater core on a 1989 Buick lesabre?

How do you install a heater core on a 1998 buick lesabre


How much does a new tail light cost for a 1998 Buick le Sabre?

The price varies for a new tail light depending on where you shop for a 1998 Buick LeSabre. The new tail light can range from $33.00-$99.00.


Do you know why there is no heat coming from the heater on a 1998 buick lesabre?

no


How much does your 1998 Buick LeSabre weigh?

The 1998 Buick LeSabre custom sedan has a curb weight of 3,443 pounds. It has a wheel base of 110.8 inches and a ground clearance of 5.5 inches.


How do you read the firing order for a Buick Lesabre 1998 165432?

165432


What type of oil do you use on a 1998 buick lesabre?

10 30


Is 1998 Buick Lesabre a front wheel drive car?

yes


What type of antifreeze does a 1998 Buick leSabre take?

Dex cool


Change struts in 1998 buick lesabre?

Struts on a 1998 Buick LeSabre are changed by jacking the vehicle up, removing the wheel, and unbolting the strut. It can then be pulled from its mounts and a new strut put in place.


How many quarts of oil does a 1998 buick lesabre hold?

4.5 leaders


What size speakers are in the back of a 1998 buick lesabre?

6" x 9"


Where is the air filter on a 1998 Buick Lesabre?

under hood left side


What is the normal range on the temp gauge for a 1998 Buick LeSabre?

220-230


Is there a certain order to tighten the bolts when replacing the transmission in a 1998 buick lesabre?

No


Where is the fuel filter located on a 1998 Buick LeSabre?

On my 98 buick LeSabre the fuel filter was under the car passenger side just in front of the rear tire.Good luck!


1998 buick lesabre license plate bulb replacement?

The license plate bulb on a 1998 Buick LeSabre is replaced by removing the retaining screws and disconnecting the wiring harness. The bulb can then be twisted from the socket and a new bulb installed.


How Do You Reset Check engine light on 98 Buick Park Ave?

The check engine light on the 1998 Buick Park Avenue can be reset by disconnecting the battery for a few minutes and then reconnecting it. The check engine light is only going to stay off if the problem that created the light is fixed.


What is the recommended tire pressure for 1998 buick lesabre?

32-35 psi


How do you reprogram a remote control for a 1998 buick lesabre?

In the owners manual it tells. On my 93 lesabre I had to jump two of the connetors on the code reader


Where is the power steering reservoir located on a1998 Buick lesabre?

The power steering reservoir is located low behind the right side of the motor very close to the fire wall on 1998 Buick Lesabre.


Where is a kick panel on a 1998 Buick LeSabre?

Area where your left foot rests while you are driving


Does 1998 Buick park ave have more interior room than a 1998 lesabre?

Yes they are built on two separate platforms, the leSabre didn't get the new platform until the 2000 model year.