The easiest way to reset the 'perform service light' on a 2003 Jeep Cherokee is to disconnect the battery for a few minutes. If this does not fix the problem, try turning the key on, but do not start the vehicle. Pump the throttle 3 times and turn the key off. Then start the vehicle. If the light is still on after that, there might still be something wrong with the vehicle.
Press the step button until "0 miles to service" is displayed. Press and hold "reset" until it resets.
you reset it by hitting step until you see "miles remaining to service" then you hold reset button and it will change to 3000
Key on and shut the doors. Press "step" until "0 miles to service" is displayed. Now press and hold "reset" until the mileage resets.
Key on and shut the doors. Press "step" until "0 miles to service" is displayed. Now press and hold "reset" until the mileage resets.
Key on and shut the doors. Press "step" until "0 miles to service" is displayed. Now press and hold "reset" until the mileage resets.
Move through the overhead display to where it says perform service. Hold down the Reset button for a few seconds and it will reset to "3,000 miles to service"
you need to drop by auto zone or your jeep dealership and have it hooked to the diog. computer. this will tell you why the light is comming on...hope this helps
Please provide photo of where it says perform service. If no photo is available, and I hope its the same as a 1993 Grand Cherokee, press select, when it says "0 miles to service" please hold the set button. That should do it.
Press the step button until "0 miles to service" is displayed. Press and hold "reset" until it resets.
Press the step button until zero miles to service is displayed. Press and hold reset.
Turn the key on. Press step until 0 miles to service is displayed. Press and hold reset.
You have to change the service light because there might be dust in the suction thingy that holds the light, and if its not that, you have to replace the wiring.