once the engine is running, press the information button until it says "service due", then keep the button pressed. "service due" will now flash, keep the button pressed, then the new "miles to next service" will be shown, release the button and it's now reset. hope this helps I tried this on an 05 megane and it did not work.In additon you must press a small button next to 150mph on the speedo until it blinks and cleers instead of keeping the button pressed. good luck
It has to be reset by a Renault dealer (or anyone with a Renault Clip diagnostic).
In order to reset the airbag light on a Renault Megane, you will need to take your vehicle into an auto body shop. You cannot reset it yourself.
how do you reset code for remote central locking on renault megane scenic v reg
using the right hand lever from the steering column, use the button to select the service screen on the dashboard screen, then depress and hold the button in on the lever. you will notice the dashboard screen flash through the various screen then after a while your service interval will be reset.
You can reset the service light by bringing of the oil life monitor on your display. Hold the scroll button in until the oil life goes to 100 percent. This should reset your service light.
renault megane 55 plate key fob starts car but does not lock car
Hold button in for 6 seconds on right lever where adjusting trip meter
The serv light means that there is a problem with the ecu,u will have to take it to a garage to get looked at
On my 2006 55 plate Dynamic you toggle the computer to display the service details, hold the button in until it changes the screen to show when the next service is due.
To reset the service indicator, start the vehicle normally. Afterwards, press the button on the end of the dashboard, and hold it in. It will begin flashing through some options, but if it is held down through the flashes, it will reset the service indicator.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
Switch ignition ON. Press the button on end of right hand stalk until spanner symbol flashes and the distance remaining to next service appears in the display. Press and hold the trip reset button for 10 secs until new service interval is displayed.let go of stalk. Turn ignition off.