You'll have to take it in so they can reset the memory code.
To remove an airbag from the steering wheel of a Corolla first make sure that the airbag system is disabled. Undo the two Tork screws on either side of the wheel. Once this is removed the connector for the airbag should be visible. Push the clip towards to horn pad and it should come out.
simply pull tha airbag fuse. remove the 4 torx head scres behind the airbag and remove airbag. unplug theelectrical connector. remove the big nut holding the steering whell. use a puller to remove the steering wheel.
On the rear of the steering wheel there is a pair of screw holes that contain torx head bolts, undo these and the airbag comes away from the steering wheel. Once the airbag is free you'll see a yellow tag that also need to be removed, once that is removed the airbag has been removed. All of this MUST be done with the battery DISCONNECTED or you risk the airbag deploying in your face. If you are unsure of the process or are not experienced please leave this to a professional.
To remove the steering wheel start by disconnecting the negative battery terminal to prevent accidental airbag deployment. Then remove the screws on the backside of the steering wheel to remove the airbag. Disconnect the airbag wiring connectors. Remove the steering column shaft nut and remove the steering wheel with a puller. Do not yank, hammer, pry the steering wheel off as this could result in steering shaft damage.
4 bolts are romoved from the backsode of the steering wheel. If airbag equipped remove airbag fuse first. Then remove airbag/ horn/ center assembly. Remove large nut from center of wheel, then pull wheel with steering wheel puller.
To remove a steering wheel, a person will need a steering wheel puller from an auto part store, from there after the airbag is removed, place the tool over the steering wheel and follow its directions. It will pull the steering wheel off by applying pressure to the middle and pulling everything else up.
Firstly your going to want to disconnect the battery or remove the airbag fuse, and wait 10 or so minutes for it to discharge. So you don't get injured from it. next there should be a small panel either side of the steering wheel that you remove with a flathead screwdriver. Once done there is 2x10mm bolts that need to be removed to take out the airbag (will need to undo the airbag wires). After that, remove the screws that hold the wheel on and yank it to remove (will need to be careful of all the wires!!)
you would need to disconnect the airbag then pop off the horn pad and remove the airbag then unbolt the steering wheel.
ok you have to check on your steering wheel in back of you steering wheel there will be a 2 or 4 bolts you gonna have to remove ,as soon your remove you steering wheel airbag you should see 2 wires one goes to airbag on other will be connected to you steering wheel switches ,,you should remove that and after that you gonna see one bolt you should remove it and you can after that you should be able to pull you steering wheel
remove the four screws that come from the backside of the steering wheel this should allow you to remove the center part be careful with the air bag connection* Disconnect the battery for thirty minutes to discharge the airbag capacitor before removing the airbag. Wear protective eyewear. Hold the airbag with the cover aimed away from you. Do not mess with the airbag electrical connections while it is disconnected.
To remove the driver's steering wheel airbag on a 1999 Holden Commodore you will need a special set of tools to remove the 4 to 6 security screws that are holding it in. If the vehicle came equipped with a airbag, it needs to have one to remain road safe.
When removing steering box the steering wheel has to be removed steering shaft is not remove able it will have to slide down when steering box is removed ie then remove pit man arm and bolts from the frame