0
How do you reset your change oil light 1994 car went from saying how much oil life left to change engine oil and every since you haven't been able to reset the indicator the holding reset doesn't work?
Wiki User
∙ 16y ago
The GM Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL message being turned on, reset the system. Always reset the engine oil life to 100% after every oil change. It will not reset itself.
To reset the CHANGE OIL message, do the following:
1. Press reset stem till it Displays "OIL LIFE" on the DIC.(3 times)
2. Press and hold the reset stem. The oil life will change to 100% and a beep will sound.
3. Turn the key to LOCK. If the CHANGE OIL message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.
Hope This Helps.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Is there a way to reset the engine oil level indicator on a 2003 Tahoe?
Change engine oil, or check oil indicator?
How do you reset service indicator Mercedes ml 270 cdi?
The service indicator light, in your Mercedes ML 270, can be reset by holding in the engine oil life button. The engine oil life will go to 100 percent. The service indicator light should go off.
How do you reset the change oil indicator on your husqvarna 2246 tractor with the Briggs and Straton v-twin engine?
Oil change indicator will come on at 49 hrs for two hrs of operation than will reset itself.
Does your check engine light in a 1993 Honda civic indicator a low fuel level?
no you have to change air sensor
How often should i change my battery in my f-150?
only need to change a battery if the battery is not holding a charge suffient to start the engine
What causes a engine knocking noise when you are accelerating and the engine is warm doesnt do it when engine is cold?
Most likely needs a tuneup done. Check the timing and change the normal tuneup part.
How do you reset check engine light after oil change was done on 2003 cvalier?
The check engine light has nothing to do with an oil change. It is an indicator of a failure of a component that will cause an increase in emissions. See related questions below for more info.
2003 Tahoe Z71 There is an indicator for the air filter How do you read the indicator to determine when it's time to change the filter The manual is of no help?
When the red sleeve shows in the window, the air filter is clogged. the indicator is connected to the engine side of the air filter, and the increase in vaccum causes the indicator to trip. It can be reset by pushing in the button on the end.
How can you fix your engine temperature indicator on your '95 civic Lx It never lift properly to show you that the engine warms up It stays at the bottom you replaced the antifreze .?
possibly change the temperature sensor???
What is watt engine indicator?
A watt engine indicator is used to perform a measurement of the amount of steam pressure in a cylinder. This process is completed with the assistance of a manometer.
Why does your car wine when you step on the gas?
It would be your cerpentine belt that runs our "extras" on your engine or your transmisson. Best thing to stop it would be to change the belt under the hood on the engine. If that doesnt work change your transmission fluids.
Why does the control indicator for engine electronics stay on?
What indicator are you referring to? Are you referring to the Check Engine light? If so, it is on because the ECU has detected a problem with the emissions system.
