0
How do you restart a 99 cadillac d elegance after you cut off the wires off the alarm?
Wiki User
∙ 15y ago
That was probably a mistake. Who suggested that you cut the wires?
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you unhook a factory alarm system on a 1998 Eddie Bauer edition Expedition?
To unhook a factory alarm system look for the alarm brain on the dash and Cut the two red and blue wires. Reconnect the wires and the alarm will be reset it self.
Changing a car alarm siren?
there is 2 wires one should be red to alarm and black to ground.
How do you disconnect the alarm on a Mazda mx3 1.8 v6?
Trace down the alarm box and cut the wires off. The alarm is not a factory option.
How can you disable the backing alarm on an ezgo golf cart?
I'd just trace the wires from the alarm itself and disconnect them
How does the wires hook up on the starter of a 1992 Cadillac Seville sts?
wiring a starter for a1992 cadillac seville
If I remove my old caralarm and pigtail the wires can I hook up the new alarm to those wires?
as long as you know what wire does what
Why would the visual alarm status indicator light on a car not flash when the alarm sounds if the bulb is good?
the wires to the bulb is one reason among others. the wires to the bulb is one reason among others.
2004 Jeep Grand Cherokee Larado and the alarm is set and no remote how do you disable it so you can start it?
You will have to uninstall the alarm and rewire the vehicle. It is likely the ignition wires are run through the alarm.
Why Factory fitted alarm for 2003 corolla wont arm?
The factory fitted alarm on a 2003 Corolla will not arm if the wires have been cut to the alarm. If the vehicle was purchased used, this is a good possibility.
How do you install Spark Plugs and wires on a 1994 Cadillac Deville Concours?
How can I change the wiring and spark plugs on my 1996 Cadillac Sedan Deville Concours?
Show 1990 buickpark avenue colored wires for ignition switch?
I have 5 wires and a 4 wire ngniton witch wires go were on a 1961 cadillac in dash ingnition. Switch
How do you disarm the door warning alarm in a 1994 940 Volvo?
Remove the switch and disconnect the wires. Then solder the wires together (making a note of polarity if there are more than 2) to create a circuit. This will then act as though the door is shut and the alarm will not sound.
