answersLogoWhite

0


Best Answer

Check the fuse. Most likely it needs to be replaced as it's both seatbelts and not just one, if it's just one, it might be a mechanical problem to which I dont have the answer.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you retract seat belts on a 1994 Mazda Protege they are stuck in the front position?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much does it cost to replace the fan belt in a Mazda Protege?

I just replaced my fan belts on a 2002 Mazda Protege. It came out to a little over $200. I took my car to a Mazda dealership.


Does the 1994 Mazda Protege have an airbag?

No, it has motorized seat belts. The 1994 Protege is essentially the same car as the 1990 Protege, which is an economy car that cost about $10,000 new.


How do you put on Serpentine belt on a 1998 Mazda protege?

This year Mazda protege does not have a serpentine belt. It has two belts, one for the alternator/water pump, and the other for the power steering and a/c.


Do 1998 Mazda protege 1.5L engine piston hit valves when broke timing belts?

No


Cost to replace a serpertine belt in a Mazda protege?

Cost for me was 120, but that is the high end. One thing to be sure of is to take it to a Mazda garage. Mazda protege's have been known to hate non-mazda belts and cause high pitched squealing after replacement.


Why wont your seat belts retract?

What year is your car if it has been in an accident the seat belts can fail as a safety precaution My vehicle is a 2005 Nissan Pathfinder. The Front Seat belts are half way out and will not retract. Can I get them to retract?


When to change timing belt on 1600cc 323 Mazda 2003?

I was looking at the Gates website ( they make timing belts etc. ) and for the 1600 cc engine in a 2003 Mazda Protege ( Canada ) it shows ( 60,000 miles )


Where is the camshaft position sensor on 2000 Mazda Protege?

Sensor is located on the top part of valve cover at the front nearer the drive belts. Three wire connector to it has wire colors Blue, Black w/ Red stripe, and White w/ Red stripe.


How many belts are on Mazda 626?

how many belts are in mazda 626


Where's the oil dip-stick on the 1998 Mazda Protege?

As you arefacing the engine compartment with the hood up, on the left side you will see a yellow handle down by the belts. This is the oil dipstick.


What causes fan belts to make noise while idling on a 1997 Mazda protege?

The belts are becoming worn and need to be replaced, or the fanbelt tensionning device needs adjustment. The only other thing it could be is that one of the things that the belts are driving is becoming seized (AC pump, power steering pump etc); but if everything else is OK then it is most probably the belts being worn out.


Where is the water pump located on a 1998 Mazda Protege?

The water pump is under the timing belt cover. To access the water pump, you must first remove both belts, the water pump pully, and the timing belt cover.