How about putting your seat belts on! If the chime is not going off when you put on the belts, take it back to the dealer.
-------------- Better Answer (for the 2007 - 2006 may be similar) - of course you should buckle up. But it nags even when your door is open or key in ignition, fast and loud. The 2009 model doesnt do this, and the dealer refused to lower the volume on my 2007.
I wouldn't recommend totally disabling it, but it is painfully loud . I finally broke down and removed it with the help of my neighbor, a mechanic. You have to remove the entire center console. There are also screws inside the storage compartment (lift the rubber liner) and on the sides. The shift knob screws off, then you lift the console out. Just a heads up, the wires wrapped in yellow tape are the airbags, no big risk. The chime is inside a small plastic box below\behind the cigarette lighter (approx 7 inches wide, remove and unsnap cover) The speaker is integrated with the circuit board. I don't recommend removing it - there are other vital items on the board. The speaker is surrounded a 1 inch deep plastic surround (part of the top cover). So, I put electrical tape directly on the speaker, and stuffed the surround with tire patches, then taped it and put everything back. Now, if you notice a few red lights, engine, etc after you put it back together, don't panic. You computer system will eventually do a self-test, mine reset after I drove for about 5 minutes and restarted the car. The muffled chime is now manageable to me. I can deal with it for at least 30 seconds if I must get in, out, or unbuckle. There you go! Oh, and those other posts about how if you disable it, it will disable the airbags are LIES according to my mechanic - they must have a separate circuit. But as I said, I can live with a quieter chime, and believe in seatbelts. Drive Safely.
You are supposed to wear your seat belt in order to stop the seat belt alarm from chiming on a Hyundai Sonata. This is an important safety mechanism that should not be tampered with.
How do you disable the alarm on the 2003 hyundai elantra?
To disable a 2002 Hyundai Elantra alarm system, put the key in the ignition. Turn the key halfway ensuring the car does not start. Leave the key in this position for 10 minutes before starting the car.
Yes, pull the fuse.
I took apart the seat belt buckle with a torx safety screwdriver and removed the metal sensor. It was driving me bananas because it would start dinging as soon as the key was in the ignition, not just when put in gear!
To disable the seat belt alarm on a Chevy Colorado, locate the alarm fuse. Pull out the fuse to disable the alarm.
annoying is'nt ?? you figure they get a better chime . how about you close the door........ And never mind the fact that if you release the seat belt while at a drive through window somewhere you have to listen to the alarm. If the engine is running and you stop and release the seat belt the alarm starts beeping! I really would like to disconnect this alarm. I wear my seat belt all the time and I am annoyed with this alarm. Our New 2011 Sonata Hybrid only beeps when you first get in, after that you can do what you want like an adult.
that easy take out your alarm out your car i m sure your alarm will be disable
You can disable the speed alarm by removing the speed alarm fuse. When the fuse is removed the alarm will not sound.
how to disable alarm on 1998 jeep grand cherokee
how do you disable rover 25 car alarm
How do you disable the alarm system on a 1998 yukok
my alarm system keep disable my car how do I reset or disable this alarm system
To disable the alarm on the Mitsubishi Montero sport without the alarm key you have to open the door. Otherwise it is not possible.
Disable the seat belt alarm in a e250
The easiest way to disable your Kia factory alarm system is to remove the alarm fuse. The alarm fuse can be found in the fuse box.
how do i disable my car alarm on a 2004 nissan Murano sl
Escape seatbelt alarm can be disabled by removing the seatbelt alarm fuse. This will disable the alarm, but it is not recommended to operate the vehicle this way.
how to silent the Hyundai getz car alarm?Type your answer here...
To disable an alarm on a Honda Civic locate the brain of the system. The brain controls the alarm. Unplug the brain from the wire harness.
The easiest way to disable your 1993 Buick factory alarm is to remove the alarm fuse. The alarm fuse can be found in the fuse box.
The easiest way to disable your 1994 Chrysler New Yorker alarm is to remove the alarm fuse. The alarm fuse can be found in the fuse box.
For instructions on how to disable a factory alarm, check out the related link below.
How do I disable seat belt alarm for a Ford F150 2004
I had this same problem! Tighten the 3 screws on your drivers door! This did the trick for us.