0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you stop 350 engine with fuel injections from idling to high?
set the idle down on the carb
Idle RPM for 350 Chevy engine?
800 rpms.
What is ignition timing and idle speed specs for a 1972 Chevy 350?
A general number for timing is around 10 but that can change based on the engine setup. The idle speed also depends on the set up but its about 900-1000 and 700-800 in gear with a stock engine.
How do you set timing 1985 GMC 350 engine?
how do you set timing on a 1985 350 gmc truck
Mechanical idle stops will always be set to a higher speed than the engine idle speed.?
Yes
Will Mechanical idle stops always be set to a higher speed than the engine idle speed?
Yes
Will Mechanical idle stops will always be set to a higher speed than the engine idle speed?
Yes
What can a 350 engine to cut off when you come to a stop?
If it is an older 350 the idle may simply be set too low. The next most common problem is low fuel pressure caused by a dirty fuel filter or weak fuel pump.
How Set idle speed on Chevy TBI 350?
There is no adjustment on a TBI fuel system, The Idle is controlled by the computer You need to check the Idle speed control solenoid. You can find that on the top left rear side of the TBI housing. It screews in, and is about 4 inches long with an electrical connecter pluged into it. Also check for a vacuum leak. If the check engine light is on then you need to scan engine with a engine scanner FIRST.
1978 350 with HEI ignition what should the timing be set at and at what RPM should the engine be running when you set it and does the vacuum advance need to be disconected?
SBC timing should be set at about 6-8 degrees advance with the vacuum disconnected at idle, about 600-800 rpm
Why would a car turn off while idling?
There are several things that could cause this. The first thing to investigate, though, is the idle speed your engine is set at. As with any engine, if the idle is set too low, the engine will not continue running.
How do you setthe timing on 350 Chevy?
how do you set the timing for a 1997 Chevy 350 5.7 engine
